OOhPaints

●  Painting Tips · 28 September 2026

Exterior painting: preparing walls for long-lasting results

By the OOhPaints team · 28 September 2026 · 7 min read

Exterior paint has a hard life. Strong sun breaks down pigments, heavy rain drives moisture into plaster, humidity encourages algae and dust settles on every ledge. Yet most early exterior failures — peeling, blistering, black streaks and chalky fading — are caused before the first coat of paint is opened. They come from preparation that was skipped or rushed.

Why preparation matters more outside

Paint is designed to bond to a clean, sound, dry surface. Outdoors, walls are rarely any of those things. Old coatings chalk into a powder, salts migrate out of masonry, fungus grows in shaded corners and hairline cracks let water behind the paint film. Painting over any of these is like sticking tape to a dusty surface: it holds for a while, then lets go.

Step 1: Inspect and record

A proper exterior job starts with a walk around the building. We look for cracks, hollow-sounding plaster, damp patches, algae, rust stains from embedded steel and areas where water collects. Each issue gets a repair method in the quotation, so you can see exactly what the preparation involves.

Step 2: Wash thoroughly

Pressure washing removes dust, pollution film, loose chalk and biological growth. Where algae or fungus is present, a biocidal wash is applied and allowed to work before rinsing. Walls must then dry completely — often a full day or more in humid conditions — before priming. Painting on a damp wall traps moisture and leads to blistering.

Step 3: Repair cracks and plaster

Fine hairline cracks can be bridged by flexible coatings, but wider cracks need to be opened up, cleaned and filled with an exterior-grade flexible filler. Hollow or crumbling plaster should be cut back and patched. Rust-stained areas around steel need the corrosion addressed, or the stain will bleed through new paint.

Step 4: Prime with the right product

New and repaired plaster is alkaline and porous. An alkali-resistant exterior primer seals the surface, evens out absorption and gives the topcoat something consistent to grip. Skipping primer often shows up as patchy colour and premature peeling.

Step 5: Choose the right finish system

  • Weather coat — a water-repellent, breathable finish for sound walls.
  • Elastomeric coating — a flexible film that stretches over hairline cracks as walls expand and contract with heat.
  • Anti-algae finish — formulated with additives that resist biological growth on shaded or damp sides.

Step 6: Apply in the right conditions

Two finish coats are standard. They should be applied in dry weather, not in direct midday sun on very hot walls, and with enough time between coats for proper drying. We plan exterior work around the forecast and stop if rain is expected before a coat can set.

Signs your exterior needs attention

  • Paint powder on your hand when you rub the wall
  • Black or green streaks below ledges and windows
  • Peeling or bubbling patches
  • Cracks wider than a fingernail

If you see these signs, a free inspection will tell you whether repainting alone is enough or whether repairs and waterproofing should come first.

Ready to start your project?

Tell us what you are planning and we will arrange a free site inspection.